Filter
Top Products
What if "F" and a number appear in the oven display?
"F15": The Self Clean
program was interrupted
during the heating phase.
Turn the program selector to "0" and then to "Light".
After 60 seconds the error message will go out,
"PYRO" and the symbol "p" will light up in the display.
After another 30 seconds the symbol "p" will flash.
Turn the program selector to "0". The oven is ready to
use.
If you still cannot operate the oven or if this error
message occurs again call Technical Service.
"F17": A temperature
sensor is defective.
The oven can still be used but, the catalytic
converter will not work properly and the Self Clean
program cannot be selected.
If the temperature sensor fails during the cleaning
program the oven door cannot be opened until the
internal oven temperature has dropped to below
530°F (280°C) and the "p" symbol flashes in the
display.
What if the timer display is dark when the oven is first turned on?
This is normal. If the time display has been turned off, the display will remain
dark. If the "Start" and "End" buttons are pressed simultaneously, "12:00" should
appear in the display.
What if the time of day cannot be entered after a power failure?
Check whether the program selector is set to "0". The time of day can only be
entered when the program selector is set to "0".
Frequently asked questions
54