Filter
Top Products
. . . there has been a power cut and
instead of the time of day, "I2:00" and
triangle V underneath the m symbol
are flashing in the clock/timer display
All pre-set times have been deleted
because of the power cut.
^
Enter the time of day again, and any
other pre-set data.
..."0:00" appears in the clock/timer
display when the Q button has been
used to switch off the buzzer
This is not a fault.
The time of day will reappear shortly.
..."F" and a number appear in the
oven display
This combination indicates a fault.
–"F 23": The pyrolytic temperature of
approx. 460 °C was not reached.
This could have been caused by too
much soiling in the oven to start with.
Remove all coarse soiling before
starting the pyrolytic cleaning
programme again.
If the fault message appears again
please contact the Miele Service
Department.
–
"F 3I": The door has not locked.
Interrupt the pyrolytic cleaning
programme by switching the oven
off. Then start it up again.
If the fault code appears again call
the Miele Service Department.
–
"F 32": The door has not locked.
Interrupt the pyrolytic cleaning
programme by turning the function
selector to "0". Then start it up again.
If the fault code appears again call
the Miele Service Department.
–
"F 33": The door lock for the pyrolytic
cleaning programme will not open.
Interrupt the pyrolytic cleaning
programme and turn the function
selector to "0". If the door lock will still
not open please contact the Miele
Service Department.
For all other fault codes please
contact the Miele Service Department.
Problem solving guide
63