Filter
Top Products
Volume
Buzzer tones
The volume is represented by a bar
with seven segments.
P P P P G G GM
Factory default: Three blocked
segments.
To change the volume touch the
"quieter" or "louder" sensor.
If all segments are blocked out the
volume is on maximum.
If none of the segments are blocked out
the volume has been turned off.
Frequency
The frequency of the buzzer can be
changed. Changing the frequency may
be necessary to optimise the volume in
different installation environments.
The frequency range is represented by
a bar with 15 segments. Each segment
represents a different frequency.
P G G G G G G G G G G G G G GM
To change the frequency touch the
sensor next to the "
-"or"+" symbols.
If the segment on the far left is the only
one blocked out (factory default) a brief
signal will sound after a short while four
times at 15 second intervals.
If more than one segment is blocked
out a continual signal will sound after a
short while for approx. 8 minutes on the
frequency set.
Keypad tone
The volume of the keypad tone, which
bleeps when touched, can be changed
or the sound switched off completely.
P P P P G G GM
Factory default: Three blocked
segments.
To change the volume touch the
"quieter" or "louder" sensor.
If all segments are blocked out the
volume is on maximum.
If none of the segments are blocked out
the volume has been turned off.
Settings
52