Filter
Top Products
After the pyrolytic process any debris
(e.g, ash), can easily be wiped away.
Remember to wait until the oven has
cooled down before doing so!
Danger of burning.
Try not to wipe over the fibre-glass
seal when cleaning the oven cavity.
It is particularly sensitive and should
not be cleaned unless absolutely
necessary. Rubbing it can damage
it.
Most residues are easily wiped away
with a damp cloth.
Depending on soiling levels in the oven
there may be visible deposits on the
door and below the trim under the oven
cavity. This is best removed using a
non-abrasive sponge or non-abrasive
stainless steel spiral pad and a mild
solution of warm water and washing-up
liquid.
Spilt fruit juices may cause lasting
discolouration to the surfaces. This
discolouration is permanent but will
not affect the efficiency of the
enamel. Do not attempt to remove
these marks.
The pyrolytic process will be
cancelled,
–
if the oven is switched off.
–
if another function is selected during
the pyrolytic process.
–
in the event of a power cut.
Switch the oven off if either of these last
two points apply.
If the oven interior temperature is below
280 °C, the door lock will be released
after a short while. It can then be
opened.
Start the pyrolytic cleaning process
again if necessary.
Cleaning and care
62