Filter
Top Products
Before using for the first time
19
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
The dosage can turn out to be higher
than the set value due to the automatic
adjustment of the Automatic program.
If spots appear on dishware and glass‐
ware:
Increase the rinse aid dosage.
If clouding or smearing appears on
dishware and glassware:
Decrease the rinse aid dosage.
Turn the dishwasher off with the
button, if it is turned on.
Press the Start button and, simulta‐
neously, switch the dishwasher on
using the button.
Keep the Start button pressed for at
least four seconds until the Start indi‐
cator light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
Press the button 3 times.
The indicator light will flash 3 times
at short intervals.
The set value will appear in the display
after .
The flashing sequence will appear in
the display.
This indicates a factory default setting
of 3.
Use the Start button to select the set‐
ting required.
Each press on the button moves you
up a level. After reaching the highest
value, the counter starts from the be‐
ginning again.
The setting is now stored in memory.
Turn the dishwasher off with the
button.