Filter
Top Products
Frequently Asked Questions
52
Water intake fault
Problem Possible cause and solution
The Intake/Drain indica‐
tor flashes on and off.
The water supply is turned off.
Turn on the water supply all the way.
The dishwasher stops
during a program.
The Intake/Drain indica‐
tor flashes.
Fault code or ap‐
pears in the display.
Before fixing the fault:
Turn the dishwasher off with the button.
There is a problem with the water intake.
Turn on the water supply fully and start the pro‐
gram again.
Clean the water intake filter (see "Frequently asked
questions").
The water pressure at the intake is lower than 4.35
psi.
Contact a plumber.
Water drainage fault
Problem Possible cause and solution
The dishwasher stops
during a program.
The Intake/Drain indica‐
tor flashes.
Fault code shows in
the display.
Before fixing the fault:
Turn the dishwasher off with the button.
There is a problem with the water intake.
There might be water in the wash cabinet.
Clean the filter system (see "Cleaning and care -
Filter system").
Clean the drain pump (see "Frequently asked
questions").
Clean the non-return valve (see "Frequently asked
questions").
Remove any kink or loop in the drain hose.