Filter
Top Products
^
Attach panel b to soft-close
mechanism bracket d.
^
Align bracket d to the hinge plate,
and insert pin e from above so that
the right angle fits into the recess.
^ Click cover f back into place.
Make sure that cover f fits properly so
that the door can be closed without
hindrance and the pin is protected.
^ Remove retaining clip g.
^
Replace panel b onto the soft-close
mechanism from above, clicking it
back into place first at the bottom
and then at the top.
^
Close the door.
Refitting the handle
Please make sure you follow the
instructions below carefully when
you refit the handle. The door seal
will be damaged if the handle is
fitted incorrectly.
^ Loosely attach the handle to the
opposite side of the door with the two
front screws b.
Mounting plate c must be positioned
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case,
^
tighten both grub screws a with a
suitable allen key until mounting plate
c lines up correctly.
^
Then tighten all 4 screws b.
^
Slide the side section of the handle
d into the guides on the mounting
plate until it clicks into place.
Changing the door hinging
48