Filter
Top Products
This appliance must be built in,
otherwise it could tip up.
Location
The appliance should be installed in a
dry well ventilated room.
The room temperature should not go
above or below the climate range for
which the appliance is designed. The
higher the ambient temperature of the
room the more energy the appliance
requires to operate. It should not be
installed where it is exposed to direct
sunlight or directly adjacent to a
heat-producing appliance such as an
oven or a radiator.
Climate range
The appliance is designed for a
particular climate range (ambient room
temperature), and should not be used
outside this range. The climate range of
this appliance is stated on the data
plate inside the appliance.
Climate range Ambient room
temperature
SN
N
ST
T
+10 °C to + 32 °C
+16 °C to + 32 °C
+18 °C to + 38 °C
+18 °C to + 43 °C
Operating in a room which is too cold
will cause the cooling system to switch
off for too long causing the internal
temperature in the appliance to rise
with the risk of food deteriorating and
going off.
Ventilation
Air at the rear of the appliance gets
warm. For the appliance to operate
efficiently it is important that it is
installed in such a way that energy loss
is kept to a minimum. The niche must
either be sealed at the back with a
kitchen furniture panel or the sides of
adjacent cabinetry and the worktop
above the appliance must abut the
kitchen wall behind the appliance. The
top of the appliance must be fitted
close to the worktop. The hole for the
plug and cable to pass through must
be made as small as possible.
Ventilation into and out of the
appliance is through the appliance
plinth. It must not be covered or
blocked in any way.
It should be dusted on a regular
basis.
Before installation
^
Remove any cable clips from the rear
of the appliance.
^
Check that all parts at the rear of the
appliance are unhindered.
Installation
29