Filter
Top Products
^
Open the door, tilt it downwards and
take it off.
^ Remove cover f, and unscrew hinge
bracket g.
^ Fit hinge pin h in the second hole of
hinge bracket g.
^ Refit bracket i and cover j turned
through 180° on the opposite side.
^
Screw hinge bracket g into the
opposite side.
The M4 screw has to be screwed into
the left hole of the hinge bracket.
^
Turn cover f through 180°, and fit it
on the other side.
^
Remove spacer k with a screwdriver
and refit it on the opposite side.
^
Remove plug l from the door
bearing bush in the door and refit on
the opposite side.
^
Unscrew tappet m.
Keep it in a safe place just in case
you ever decide to change the door
hinging back to right hand hinging.
^
Screw the tappet supplied n into the
opposite side using the same screw
o.
^
Hang the door on hinge pin h and
then close the appliance door.
In the following illustration the door
is not shown in the closed position to
make it easier to see what happens
next.
^
Turn door support b through 180°,
pull hinge pin a out, and then fit both
parts into hinge plate f:
To do this push hinge pin a the other
way round through hinge plate f into
door support b. Swing the door
support in, push upwards and
re-assemble with screw c.
Changing the door hinging
32