Filter
Top Products
^
Secure the appliance in the housing
unit using the short 4 x 14 mm
screws b through the bottom hinge
plates and then tighten them up.
^
Screw fixing bracket e back on (if
this has not already been done).
^
Secure the appliance to the housing
unit wall on the door opening side
using two 4 x 14 mm screws through
the upper fixing bracket a and one 4
x 14 mm screw f through fixing
bracket e and then tighten them.
^
Close the fixing bracket a back up
again and fit cover g.
^
Align cover strip h by sliding it
parallel to the housing unit ceiling.
The cover strip must not protude.
^
Secure the appliance to the top of the
housing unit using the short 4 x 14
mm screws i through the cover strip
before tightening them.
Fitting a furniture door
^
Fit the door coupling parts a to the
appliance door at handle height
using the 3.9 x 9.5 mm self tapping
screws b (on a larger door an extra
door coupling should be fitted). Use
the pre-drilled holes.
^
Open the doors right out and push
the coupling guides c into the door
coupling parts.
Building in the appliance
49