Filter
Top Products
Problem Possible cause Remedy
The sensors are
over-sensitive or
do not react at
all.
The sensitivity level of the
sensors has changed.
Make sure that there is no
direct light (from the sun or
from an artificial source)
falling onto the hob and that
the surrounding area is not
too dark.
Make sure that there is
nothing covering the sensors
or the hob. Take any pans off
the hob and wipe away any
food deposits.
Interrupt the power supply to
the hob for approx. 1 minute.
If this does not solve the
problem, please call the Miele
Service department.
An F lights up in
the rear left
cooking zone
display and an E
lights up in the
rear right cooking
zone display and
numbers appear
in the displays at
the front.
left right
90A calibration fault has
occurred after the reset
function has been activated
or after an interruption to the
power supply. If the displays
do not go out after 5 minutes,
proceed as described under
"Remedy" on the right.
91
92
93
37The overheating protection
mechanism for the control
panel has triggered.
No remedy necessary.
You can use the hob again as
soon as the fault code goes
out (see "Overheating
protection").
All other fault
codes
A fault with the electronics
has occurred.
Interrupt the power supply to
the hob for approx. 1 minute.
If the problem persists after
reconnecting the appliance to
the power supply, please
contact the Miele Service
department.
Problem solving guide
42