Filter
Top Products
Technical safety
~
Before installation, check the
appliance for visible signs of damage.
Do not install and use a damaged
appliance. It could be dangerous.
~
The electrical safety of this
appliance can only be guaranteed if
correctly earthed. It is most important
that this basic safety requirement is
observed and regularly tested, and
where there is any doubt, the electrical
system in the house should be
inspected by a qualified electrician.
Miele cannot be held liable for the
consequences of an inadequate
earthing system (e.g. electric shock).
~
Before connecting the appliance,
make sure that the connection data on
the data plate (voltage and frequency)
match the mains electricity supply.
This data must correspond in order to
avoid the risk of damage to the
appliance. Consult a qualified
electrician if in any doubt.
~
For safety reasons, this appliance
may only be used after it has been built
in.
~
Do not open the casing of the
appliance.
Tampering with electrical connections
or components and mechanical parts is
highly dangerous to the user and can
cause operational faults.
~
Installation, maintenance and
repairs may only be carried out by a
suitably qualified and competent
person in strict accordance with current
national and local safety regulations.
Repairs and other work by unqualified
persons could be dangerous. Miele
cannot be held liable for unauthorised
work.
~
During installation, maintenance and
repair work, the appliance must be
disconnected from the mains electricity
supply.
Ensure that power is not supplied to the
appliance until after it has been
installed or until after any maintenance
or repair work has been carried out.
~
While the appliance is under
guarantee, repairs should only be
undertaken by a service technician
authorised by Miele. Otherwise the
guarantee is invalidated.
~
Faulty components must only be
replaced by genuine Miele original
spare parts. The manufacturer can only
guarantee the safety of the appliance
when Miele replacement parts are
used.
~
If the connection cable is damaged,
it must be replaced by a suitably
qualified electrician with a specialist
connection cable of type H 05 V V-F
(pvc insulated), available from Miele.
Warning and Safety instructions
13