Miele KWT 1611 Vi Refrigerator User Manual


 
It is possible to set the exact
temperature individually in each zone.
The zones are set up ex works to store
red wine, white wine and for long-term
storage.
The settings can be altered to your
requirements.
^
Touch the sensor for the zone you
wish to change so that it is
highlighted in yellow.
^ The temperature inside the appliance
can be selected by touching the
arrow sensors on either side of the
temperature display.
The temperature set at the factory for
the zone concerned is highlighted in
yellow.
By touching the
X sensor: the temperature will get
colder
Y sensor: the temperature will get
warmer.
Touching the sensor once:
adjusts the temperature shown in
1 °C steps.
Keeping your finger on the sensor:
changes the temperature
continuously.
If the highest or lowest temperature that
it is possible to set is reached, the X or
Y sensor will disappear from the
display.
The temperature display in the
control panel always shows the
required temperature.
Once you have altered the temperature,
check the temperature after a few
hours. It will take this long for the
appliance to reach the temperature. If,
after this time, the temperature is still
too high or too low, you will need to
adjust it again.
Temperature ranges for each of the
zones
Upper zone:
Cto1C
Middle zone:
Cto1C
Lower zone:
Cto1C
The ideal temperature and humidity level
17