Filter
Top Products
Water hardness
The dishwasher is equipped with a
sensor softener, which automatically
detects the hardness of your tap water.
After plumbing the dishwasher and
finishing a program, e.g. "Rinse &
Hold", the water hardness is displayed
in the menu "Water hardness".
^
Touch
OK to go back to "Settings J".
Rinse aid
For best results, the rinse aid dosage
can be adjusted.
The dosage can be set in steps from 0
to 6 ml.
The dosage set by default to 3 ml of
rinse aid per program.
^ Use a higher setting if spots appear
on dry glassware.
^ Use a lower setting if streaking
appears on dishes or glasses.
^
Select the desired rinse aid dosage
with the
+/- controls and confirm with
OK.
Filter check
This selection allows you to set the
number of cycles run before the filter
check message shows.
You can select between 30 and
60 cycles.
The filter check message is set by
default to 40 cycles.
^
Select the desired interval and
confirm with
OK.
Adjust Sensor Wash
The "Sensor Wash" program can be
adjusted to clean stubborn but normal
soiling.
^ Select
Yes to activate this function
and confirm with
OK.
Settings J
44