Filter
Top Products
Grilling Chart
Cooking time depends on the thickness of
the meat and not on its weight.
Type of food
Mins per side
Bacon rashers 2 - 5
Chicken joints 15 - 20
Gammon rashers 5 - 8
Lamb chops 6 - 12
Pork chops 10 - 15
Sausages
(turning as required)
10 - 12
Steaks (average thickness)
Rare 3 - 6
Medium 6 - 10
Well done 8 - 12
Toast 1 - 1
1
/
2
Grilling must be carried out with
the oven door closed. The grill pan
handle must be removed from the pan.
SYMPTOM
The oven does not come on
The oven temperature light does not
come on
The oven light does not come on
It takes too much time to finish the dishes,
or they are cooked too fast.
Steam and condensation settle on the
food and the oven cavity.
SOLUTION
Check that both a cooking function and
temperature have been selected.
Check the appliance is wired in properly,
and the socket switch or the switch from the
mains supply to the oven are ON.
Select a temperature with the thermostat
control knob
Select a function with the oven function
control knob.
Select a function with the oven function
control knob
Check the light bulb, and replace it if
necessary (see above)
The temperature may need adjusting
Refer to the contents of this booklet,
especially to the chapter “Using the Oven”.
Leave dishes inside the oven no longer than
15-20 minutes after the cooking is completed.
Something not working
If the appliance is not working correctly, please carry out the following checks, before contacting
your local Service Force Centre.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by
incorrect use or installation, a charge will be made even if the appliance is under guarantee.
Replacing The Oven Light
Disconnect the appliance
If the oven bulb needs replacing, it must comply
with the following specifications:
Electric power: 15W; Electric rate: 230-240V
(50 Hz); Resistant to temperatures of 300°C;
Connection type: E14.
These bulbs are available from your local
Service Force Centre. To replace the faulty
bulb:
1. Ensure the oven is isolated from the
electrical supply.
2. Turn the glass cover counterclockwise.
3. Remove the faulty bulb and replace with
the new one.
4. Refit the glass cover and restore the
electrical supply.