Filter
Top Products
14
1. Push the POWER switch up to the ON position. The switch illuminates, water enters the wash
compartment. The booster heater begins to heat the nal rinse water then the wash tank heater
heats the wash tank water.
2. Wait 10 minutes for the booster to reach temperature. Then, run 2-3 empty cycles before inserting
your rst rack of dishes.
3. Prescrap and load wares into the appropriate dishrack. Do not overload dishrack. Load wares in a
peg rack; load silverware in a single layer in a at-bottom dishrack. Overloading dishrack will result
in poor washing results.
4. Open dishwasher door and slide dishrack into the machine. Load 1 dishrack per wash cycle.
5. Close the dishwasher door. Press and hold START button for 1 second.
The cycle light illuminates and the wash cycle begins.
NOTE:
Make sure the wash temperature is a minimum of 150°F/66°C for high temp models and a
minimum of 140°F/60°C for low temp models before beginning the wash cycle.
Operation
501HT Control Panel
Normal Wash Cycle
PRIME
DET
R/A
Wash Temperature
Digital Display
Final Rinse Temperature
Digital Display
Scrub
In-cycle Light
In-cycle Light
ON/OFF
Power Switch
Scrub
Push button
Prime Switch
Start Push button
All 201, 401 Control Panels
I
O
START POWER
PRIME
OFF / DRAIN
ON
DET
R/A
Prime Switch
Start
Push button
In-cycle Light
ON/OFF
Power Switch
NOTE:
Opening the door stops the cycle. When the dishwasher door is closed the cycle resumes automatically.
The dishwasher cycle will reset to the beginning If the door is open for more than 5 second.