OPERATION SUMMARY
1. Push the On/Off power switch “UP” to
the ON position. Dishwasher fills
automatically.
2. Wait approximately 10 minutes for the
wash tank heater to heat the water. Then,
check the reading on the wash water
temperature gauge.
3. Prescrap and load the ware into the
dishrack.
4. Open the doors.
Insert a dishrack of soiled ware.
Fully close the doors.
Opening the doors anytime during the
automatic cycle stops the dishwasher.
Closing the doors will resume the cycle
where it left off.
5. Check the final rinse temperature
gauge reading during the 8 second
final rinse cycle.
6. Check the incoming water pressure
during the 10 second final rinse cycle.
7. The 60 second automatic cycle ends.
8. Open the doors. Remove the clean rack.
Insert another rack of soiled ware.
Fully close the doors.
9. Turn power OFF at the dishwasher.
Remove the drain-overflow assembly.
Clean the scrap screens. Clean the
dishwasher after each meal period or
every two hours of operation.
1. The power indicator light illuminates. The
wash tank heater and the booster tank heater
begin to heat.
2. The wash water temperature gauge should
indicate a minimum of 150°F/66°C for MH-
60, MH-6N and 120°F/60°C for MH-6L.
3. Ware should be placed edgewise in the peg
rack. Cups and bowls should be placed upside
down in the flat rack. Silverware should be
spread evenly in a single layer in the flat rack.
4. In-cycle light illuminates as the dishwasher
begins a 60 second automatic cycle.
The cycle times are listed below:
Wash = 48 seconds
Dwell = 4 seconds
Final rinse = 8 seconds
5. The final rinse temperature gauge should
indicate a minimum of 180°F/82°C for MH-
60/6N. The optimum final rinse temperature
range is between 180-195°F/82-90°C for
MH60/6N. MH-6L optimum is 140°F/60°C.
6. The water pressure gauge should indicate a
flowing pressure of 20-22 PSI/138-151.8 kPa.
A pressure reducing valve (PRV) is required if
flow pressure exceeds 20-22 PSI/138-151.8 kPa.
7. The in-cycle light goes out.
8. The 60 second automatic cycle begins again.
9. Dishwasher wash tank drains completely.
Periodic cleaning reduces detergent
consumption and improves washing results.
17
OPERATION
Action Result