Holder with one hand while pushing up on the bottom
of the K-Cup
®
portion pack Holder from underneath with
the other until it releases. After cleaning, align the K-Cup
®
portion pack Holder with the opening using the two front
ribs as a guide, and snap into place from the top.
Cleaning the K-Cup
®
Portion Pack Holder Assembly
1. Cleaning the Parts – The K-Cup
®
portion pack Holder
Assembly can be placed onto the top shelf of a
dishwasher. NOTE: Use low temperature cycles in the
dishwasher. To remove from the Brewer, lift the front face
of the Brewer. Grasp the top of the K-Cup
®
portion pack
Holder with one hand while pushing up on the bottom
of the K-Cup
®
portion pack Holder from underneath
with the other until it releases. After cleaning, align the
K-Cup
®
portion pack Holder with the
opening using the two front ribs as a
guide, and snap into place from the
top.
2. Cleaning the Funnel – The Funnel
can be removed from the K-Cup
®
portion pack Holder by pulling on it
until it snaps off (fig. 1). The Funnel
is dishwasher safe. To replace it, just
snap it back onto the K-Cup
®
portion
pack Holder Assembly.
3 Cleaning the Exit Needle – The Exit
Needle is located on the inside
bottom of the K-Cup
®
portion pack
Holder Assembly. Should a clog
arise due to coffee grinds, it can be
cleaned using a clean household tool. Remove K-Cup
®
portion pack Holder assembly and detach Funnel. Insert
the household tool into the Needle to loosen the clog and
push it out. The K-Cup
®
portion pack Holder is dishwasher
safe.
!
FIGURE 1
CAUTION:There are sharp needles that puncture the
K-Cup
®
portion pack above the K-Cup
®
portion pack
Holder and in the bottom of the K-Cup
®
portion
pack Holder. To avoid risk of injury, do not put
your fingers in the K-Cup
®
portion pack Assembly
Housing.
Cleaning and Emptying the Reservoir
Discard the remaining water by removing the reservoir
lid and turning reservoir upside down over the sink. It is
recommended to empty the water reservoir between uses
and use fresh water for each brew. Do not immerse appliance
in water.
Storage
Empty the reservoir before storing and take care to ensure that
you store your Brewer in a safe and frost free environment.
It is suggested to store your Brewer in the upright position. If
you store the Brewer in a cold environment, you run the risk of
condensation freezing inside the Brewer and causing damage.
When you prepare to use it after storage, we recommend
wiping the reservoir with a damp lint-free cloth and running
three cleansing brews without a K-Cup
®
portion pack.
If your Brewer has been in an environment below freezing,
please be sure to let it warm to room temperature for 2
hours before using.
De-Scaling Your Brewer
Mineral content in bottled or filtered water varies. Depending
on the mineral content of the water, calcium deposits or
scale may build up in your Brewer. Scale is non-toxic but left
unattended, it can hinder Brewer performance. Descaling
your Brewer helps maintain the heating element, and other
internal parts of the Brewer that come in contact with water.
The Brewer should be de-scaled every 3-6 months to ensure
optimal performance or when there are white deposits in the
reservoir. It is possible for calcium deposits to build up faster,
making it necessary to de-scale more often.
12 13
BVMC-KG5_11ESM1.indd 13-14 11/11/11 4:00 PM