Filter
Top Products
Post-installation Steps
Nokia Intellisync Mobile Suite Linux Installation Guide 23
5. After the installation completes, open a Web browser and type the following URL to access
WebAdmin Console.
http://<serveraddress>/admin
Post-installation Steps
Verifying GroupWise Mobile Server Requirements
For the GroupWise Mobile Server to run properly, verify that your GroupWise server meets the
following requirements.
! GroupWise Internet Agent must be installed on the GroupWise server, as it is needed by the
SOAP interface used by the GroupWise translator. Refer to your Novell GroupWise
documentation for more information about installing GroupWise Internet Agent.
! If you use a firewall, you must have the following ports open.
! Port 80 for HTTP Web access and device synchronization
! Port 443 for secure Web access (HTTPS) and Windows Mobile Provisioning
! Port 3102 for Network Push (required only if you use the Network Push feature)
Configuring the GroupWise Mobile Server
There are several configuration changes that must be made to synchronize successfully with a
GroupWise account.
! External server names must be set correctly. For example, Web Site Server, Sync Server, and
Network Push Server. Using the WebAdmin Console, go to System Settings > Server Names
and verify the external server names are set correctly to your external IP address / DNS
names.
! You can create authentication sources using the WebAdmin Console. Go to System
Settings > Authentication > Sources > New GroupWise.
Note: If you are using a GroupWise authentication source and your GroupWise server
requires Secure Sockets Layer (SSL) for SOAP access, select the “Use SSL” option.
Afterward, go to User Settings > Wireless Email > Novel GroupWise. From the Novell
GroupWise Access tab, click Edit, and then select the “Use SSL” option. After you create a
GroupWise authentication source, log out of WebAdmin Console and then log in again to
make the authentication source visible on the Create User page.
! To add the GroupWise server address for your users, go to User Settings > Wireless Email >
Novel GroupWise. From the Novell GroupWise Access tab, click Edit and enter the server
address.
! To allow end users to add or remove GroupWise connections, go to User Settings > Email
Accelerator > Novel GroupWise. From the Novell GroupWise User Settings tab, click Edit
and select the first three options.