Filter
Top Products
ENGLISH
8
REGULATOR
The Double Regulator works the
CO
2
Tank and measures PSI (pounds
per square inch), as well as the volume of the
CO
2
gas in the Cylinder.
Set Output Pressure Gauge between 8-12 PSI for a nice, frothy head.
Close the Shut Off Valve on the Double Regulator, and 1.
open the CO
2
Tank Valve (#9) completely.
Unlock Screw using Allen Wrench (included). Slowly turn the Double 2.
Regulator adjustment screw until the desired pressure is shown on the
Output Pressure Gauge (8-12 PSI). Turning clockwise will increase the output
pressure, and turning counter-clockwise will decrease the output pressure.
Once desired pressure is reached, you may re-lock Screw using Allen Wrench.
3.
Open the 4. CO
2
Shut Off Valve on the Double Regulator to allow gas flow
from the Double Regulator to the Keg Coupler. You will hear the keg
pressurizing. The output needle will drop momentarily until the pressure
has equalized. Then the needle will return to the point you set it at.
The Keg Coupler is designed with a pressure relief valve (PRV). 5.
Pull the ring on the PRV briefly to allow gas to vent. This will
permit gas to flow through the Double Regulator and help obtain
a more accurate reading on the Output Pressure Gauge.
Re-check the output pressure on the Double Regulator, and if necessary 6.
re-adjust using step #2 until the desired pressure is shown. It is always
wise to follow up any adjustment to the Double Regulator with a
brief pull of the PRV ring to ensure an accurate output reading.
Tank
Pressure
Gauge
(0-3000 PSI)
for measuring
PSI of
CO
2
in tank.
Output
Pressure
Gauge
(0-60 PSI) for
measuring PSI
of
CO
2
outflow
from Tank to Keg
(8-12 PSI
recommended).
Screw adjusts
the output
pressure.
Pressure Relief Valve
CO
2
Shut Off
Valve (shown in
open position)