Filter
Top Products
ENGLISH
10
CO
2 & TAP TOWER INSTALLATION
You must read and understand the steps below for the CO
2
assembly before
installation. When you purchase the first keg of beer, you must also have your
CO
2
cylinder filled at your local supplier.
CO
2
tanks can be refilled at locations
such as welding supply shops, party stores, or wherever kegs are purchased.
(cont. on next page)
STEP 1
Make sure white nylon High Pressure
Washer (already installed) is attached
to
CO
2
Double Regulator.
STEP 2
Use Wrench to attach Double
Regulator to
CO
2
Tank connector.
STEP 3
Remove spring from inside the
Keg Coupler. If spring is not
present, go on to Step 4.
STEP 4
Make sure Backflow Stopper
is insterted in the Keg Coupler
(the Backflow Stopper goes in
with rounded side down).
STEP 5
After the Backflow Stopper has been
inserted, remove the three parts above.