Filter
Top Products
- 18 -
How to Operate
H. CYCLE COUNTER
4ODISPLAYALLCOOKINGTIMESEVERUSED
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
1
Open the door and leave it open.
The oven lamp will turn on and “0” will appear.
2
While pressing Start pad, press Number/Memory pad “3”.
All the cooking times that were ever used appear.
e.g.
4ODISPLAYTHECUMULATIVENUMBEROFTIMESTHEOVENWASUSED
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
1
Open the door and leave it open.
The oven lamp will turn on and “0” will appear.
2
While pressing Start pad, press Power Level Selector pad.
The number of cycles that the oven has been used will appear.
Note: The last two digits are dropped from the cumulative number of
times the oven was used, which is displayed in units of 100 when
used over 100 times.
e.g.
I. AIR FILTER CLEANING
Example: To program cleaning Air Filter every 600 hours
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
1
Open the door and leave it open.
The oven lamp will turn on and “0” will appear.
2
While pressing Start pad, press Number/Memory pad “7”.
The currently programmed hour will appear.
e.g.
3
Press Number/Memory pads “6”, “0” and “0”.
The programmed hour will appear.
Note: up to 9999 hours
e.g.
4
Press Prog pad.
“PROG” will stop blinking, and the set hours will appear for 3 seconds.
Then “0” will appear.
e.g.
Note: When “FILt” sign appears in Digital Display Window, remove Air Filter and clean it with soapy water.
Press Stop/Reset pad for 2 seconds to clear the display.
How to release the “FILt” sign
Press and hold down the Stop/Reset pad for 2 seconds.1.
The “FILt” sign is released and the buzzer sounds.2.
* If the Stop/Reset pad is not held down long enough, the “FILt” sign will disappear once but will reappear again
after the screen goes blank.