Filter
Top Products
- 15 -
4O2ELEASE0ROGRAM,OCK
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
1
Open the door and leave it open.
The oven lamp will turn on, and “0” will appear.
2
While pressing Start pad, press Prog pad until “PROG” and “P”
appear. (more than 2 seconds)
“PROG” and “P” will appear.
3 seconds later, “0” will appear.
In Program Unlock mode:
s /VENREVERTSTOATWOPRESSOPERATINGMODE.UMBER-EMORYPAD3TARTPAD
s 2EPEATANDINTERRUPTFEATUREAREOPERATIONAL
s .UMBER-EMORYPADSCANBEPROGRAMMED
s 4ONELOUDNESSCONTROLLENGTHCONTROLANDPITCHCONTROLBEEPTONEATTHEENDOFHEATINGCYCLEFILTERCLEANING
alarm) are operational.
F. BEEP TONE
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (See pages 14-15)
The loudness of beep tone, the length of beep tone at the end of heating cycle, the pitch of beep tone at the end of
heating cycle and the pitch of filter cleaning alarm can be set.
Begin with step 1 and follow the procedure to change either the length of beep tone at the end of heating cycle, the
pitch of beep tone at the end of heating cycle or the pitch of filter cleaning alarm.
Example: Change the volume to “middle (2bEEP)”, the length of beep tone at the end of heating cycle to
2nd, the pitch of beep tone at the end of heating cycle to “Low”, and the pitch of filter cleaning
alarm to “Low”.
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
1
Open the door and leave it open.
The oven lamp will turn on, and “0” will appear.
2
Press Prog pad.
3
Press Start pad.
“PROG” will start to blink.
The display changes to “3bEEP”, “2bEEP”, “1bEEP”, and “0bEEP”
each time the Start pad is pressed and the settings change.
*The loudness of beep tone
3bEEP: loudest, 2bEEP: middle, 1bEEP: quietest, 0bEEP: silent
4
Press Prog pad.
“PROG” will stop blinking, and the set loudness of beep tone will
appear for 3 seconds.
Then “0” will appear.
To proceed to Step 5, press Start pad before “0” is displayed after Step 4.
How to Operate
Continue