Panasonic NN-SD277 Microwave Oven User Manual


 
10
Setting the Clock
Example: To set 11:25
1.
Press Clock once.
Colon flashes.
2.
Set time of day using Pop-Out Dial.
Time appears in the display window;
colon continues flashing.
3.
Press Clock.
Colon stops flashing; time of day is
entered.
NOTES:
1. To reset the clock, repeat step 1-3.
2. The clock will retain the time of day as long as the oven is
plugged in and electricity is supplied.
3. Clock is a 12 hour display.
4. Oven will not operate while colon is flashing.
Selecting Light On/Night/Off
This feature allows you to control the
brightness of Cooktop Light.
Press "Light On/Night/Off" pad once for
bright light, twice for the night light, and
press again to turn the light off.
NOTE:
When "Turntable OFF" is selected, it will automatically return
to "ON" again after the heating cycle is completed.
Do not operate the oven "Turntable Off" when cooking foods
on Popcorn / Inverter Turbo Defrost / Sensor Reheat / Sensor
Cook.
Sometimes the turntable can become too hot to touch. Be
careful when touching the turntable during and after cooking.
Selecting Turntable On/Off
For best cooking results, leave the
turntable on. It can be turned off for
large dishes.
Press "Turntable On/Off" pad to turn the
turntable on or off.
When you turn it off, will appear in
the display window.
NOTE: Automatic Fan
If the microwave oven is used for a long time or if cooking
equipment under the microwave oven is used simultaneously,
the temperature may get too hot around the microwave oven
and the vent hood fan will automatically turn on at the Turbo
setting to cool the oven. When this occurs the display window
shows "VENTILATING", and the fan can not be manually
turned off. If subsequently another key is pressed and "HOT"
appears in the display window, the microwave oven will not
operate, and you must wait until the microwave is cool and
"HOT" disappears from the display to re-program. The fan will
automatically turn off when the internal components are cool. It
may continue cooling for 30 minutes or longer.
When "COOLING" appears in the display window
After either using the microwave oven for a long time or using
the cooking equipment under the microwave, "COOLING" may
appear in the display window, and the cooling fan will run until
components inside are cool. The microwave oven will continue
to operate normally.
When "HOT" appears on the Display Window
When using the microwave oven and the cooking equipment
under the product simultaneously, "HOT" may appear on the
display window and the microwave oven does not work. In this
case, wait until the microwave oven is cool and "HOT" disap-
pears. It may stay on until it is finished performing the cooking
operation.
Selecting Fan High/Low/Off
The Fan (Vent Fan) reduces steam and
other vapors from the cooking surface
below the microwave oven. Press "Fan
High/Low/Off" pad once for High fan
speed, twice for Low fan speed, and
press again to turn the fan off. When
you turn it on, will appear in the
display window.
NOTE: If Auto Off is touched after Auto Off time had been set,
you must reset the time.
one tap
two taps
three taps
four taps
five taps
1 min
3 min
5 min
10 min
Selecting Auto Off 1/3/5/10
After you have selected Fan High/Low
or Super Fan/Turbo Fan On, you can
set the desired time that automatically
turns off the Fan or Super/Turbo Fan.
Press "Auto Off 1/3/5/10" pad to set fan
time. The following is the set times for
the number of taps to the key:
Selecting Super/Turbo/Off
Use "Super/Turbo/Off" pad for maxi-
mum fan speed.
Press "Super/Turbo/Off" pad once to
turn on the Super Fan, twice to turn on
the Turbo Fan, and press again to turn
it off. When you turn it on, will
appear in the display window.
Pop-Out & rotate
IP1016_38Q10AP_05_070515 2007.5.15 20:17 Page 12