18
Timer Feature
Example: To count down 5 minutes.
1.
• Press Timer.
2.
• Set time, using Pop-Out Dial.
3.
• Press Start.
➤Time will count down without oven
operating.
NOTE:
1. When each stage finishes, a two-beep signal sounds. At the
end of the program, the oven will beep five times.
2. If the oven door is opened during Stand Time, Kitchen Timer
or Delay Time, the time on the display will continue to count
down.
3. Stand time and Delay start cannot be programmed before
any automatic Function. This is to prevent the starting tem-
perature of food from rising before defrosting or cooking
begins. A change in starting temperature could cause inac-
curate results.
4. The maximum programmable time of Standing Time,
Kitchen Time or Delay Time is up to 99 minutes and 30 sec-
onds.
This feature allows you to program the oven as a kitchen timer.
It can also be used to program a standing time after cooking is
completed and/or to program a delay start.
To Use as a Kitchen Timer:
CAUTION:
If oven lamp is lit while using the timer feature, the oven is
incorrectly programmed. Stop oven immediately and
re-read instructions.
To Set Delay Start:
Example: To cook at P6 power for 3 minutes, with stand
time of 5 minutes.
1.
• Enter the desired Power Level (see
page 11 for directions).
2.
• Set cooking time, using Pop-Out Dial.
3.
• Press Timer.
4.
• Set stand time, using Pop-Out Dial.
5.
• Press Start.
➤Cooking will start. After cooking,
stand time will count down without
oven operating.
To Set Stand Time:
Example: To delay the start of cooking for 5 minutes, and
cook at P6 power for 3 minutes.
1.
• Press Timer.
2.
• Set delay time, using Pop-Out Dial.
3.
• Enter the desired Power Level (see
page 11 for directions).
4.
• Set cooking time, using Pop-Out Dial.
5.
• Press Start.
➤Delay time will count down. Then
cooking will start.
Press 5 times
Pop-Out & rotate to
5 minutes
Pop-Out & rotate to
3 minutes
Rotate to 5 minutes
Press 5 times
Pop-Out & rotate to
5 minutes
Rotate to 3 minutes
IP1016_38Q10AP_05_070515 2007.5.15 20:17 Page 20