Filter
Top Products
– 36 –
Care of your Microwave Oven
BEFORE CLEANING:
Unplug at socket of the oven. If impossible,
leave oven door open to prevent oven from
accidentally turning on.
AFTER CLEANING:
Be sure to replace the Roller Ring and Glass
Tray in the proper position and press
Stop/Reset Pad to clear the Display Window.
Inside of the oven:
Wipe with a damp cloth. Mild
detergent may be used if the oven
gets very dirty. The use of harsh
detergent or abrasives is not
recommended.
Glass Tray:
Remove and wash in warm soapy
water or in a dishwasher. If grease
accumulates, clean with a non-
abrasive nylon mesh scouring pad
and a non-abrasive cleanser.
Outside oven surfaces
and back vents.
Clean with a damp cloth.
To prevent damage to the
operating parts inside the
oven, water should not be
allowed to seep into
ventilation openings.
Oven Door:
Wipe with a soft cloth when steam accumulates
inside or around the outside of the oven door.
This may occur when the microwave oven is
operated under high humidity conditions and in
no way indicates a malfunction of the unit or of
microwave leakage.
Roller Ring and oven cavity floor:
Wipe the bottom surface of the oven with mild
detergent water or window cleaner and dry.
Roller Ring may be washed in mild soapy
water or dishwasher. These areas should be
kept clean to avoid excessive noise.
Control Panel:
•May be covered with
removable protective film to
prevent scratches during
shipping. Small bubbles
may appear under this film.
When this happens, remove
film carefully.
(Hint - apply masking or clear
tape to an exposed corner
and pull gently to remove.)
•If it becomes wet, clean
with a soft, dry cloth. Do
not use harsh detergents
or abrasives on the Control
Panel.
Power Supply*: 230 - 240 V
50 Hz
Power Consumption: 5.1 A 1,175 W
Output:** 850 W
Outside Dimensions (H x W x D): 284 x 482 x 346 mm
Oven Cavity Dimensions (H x W x D): 191 x 325 x 330 mm
Operating Frequency: 2,450 MHz
Uncrated Weight: Approx. 9.5 kg
**Voltage requirement may differ by country. Check your identification plate for power supply voltage required.
**IEC Test Procedure Specifications subject to change without notice.
Technical Specifications