Filter
Top Products
INSTALLATION
1. PARTS REQUIRED
The loose hotplate parts and battery are packed in the polystyrene fitment on top of the hotplate.
2. LEVELLING THE APPLIANCE
If the appliance requires levelling or its height adjusting (from the hotplate to any working surface), the
procedure below must be followed:
1. Loosen the lock nuts securing the rear wheels, using a 13mm spanner. Access to these lock nuts can
be gained through a slot in the rear of the plinth, as shown in Fig.1c.
2. Adjustment to suit floor conditions or height is obtained by rotating clockwise or anticlockwise the
hexagonal feet/wheels, at the front and rear of the appliance.
NOTE: The rear wheels must only be rotated through half or whole turns.
3. A spirit level should be placed on one of the oven shelves to confirm the appliance is correctly levelled.
4. Once the appliance is at the correct height and levelled, the rear wheel should be locked into position by
means of the lock nuts, having first made sure the wheels are once again parallel to the side of the appliance.
3. FITTING THE STABILITY BRACKET
35
S H E R A T O N
Rear of
Appliance
Plinth
Lock Nut
Rear Wheel
Fig. 1c