Filter
Top Products
be installed with an appliance flexible connection only.
Supply piping should not be less than R³/8. Connection is
made to the Rc ½ (½" B.S.P.) female threaded entry pipe
located just below the hotplate level on the rear left hand
side of the appliance.
NOTE: ONLY LIQUID SEALANTS
TO BE USED WHEN INLET GAS PIPE IS FITTED TO
RESET VALVE I.E.: DO NOT USE P.T.F.E. SEALANT
TAPE.
Check for gas soundness after connecting the gas supply.
The gas bayonet connector must be fitted in the shaded
area indicated in Fig. 3. Take into account that it must be
possible to pull the appliance forward sufficiently. The
hose must not get caught on the stability bracket.
IMPORTANT: FLEXIBLE TUBING USED MUST
COMPLY WITH BS. 669 CURRENT EDITION.
L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A
TYPE SUITABLE FOR L.P.G. AND CAPABLE OF
OPERATION UP TO 50 mbar AND TO CARRY A RED
STRIPE, BAND OR LABEL.
5. FITTING THE BATTERY
1
. The battery is located on the left hand side of the front plinth and can be viewed through a slot in the
bottom left hand corner of the front frame( Fig 4.)
2. To gain access to the battery, pull the appliance forward, raise and support the front by a few (2-3)
centimetres).
3. Fit the battery AA size ensuring the positive + terminal is on the right hand side as shown in the
diagram. The battery may be pushed out of the holder by using a blunt implement, such as a spoon
handle through the slot in the front frame if necessary.
4. Lower the appliance and push it back into place.
6. PRESSURE TESTING
1 The oven injector is used as a pressure test point.
37
S H E R A T O N
200
400
650
250
Fig.4
Fig.3