Filter
Top Products
Form No. Z2323
Rev. 06.26.10
4
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
Installation and Tapping
ArctiCold Draft Dispenser
Tapping a Single Valve Keg (Sankey)
■
Be sure beer faucet is in closed position.
■
Align keg lugs with lug openings on bottom
of coupler.
■
Turn clockwise
1
⁄4 turn. Pull handle out and
down. Keg is now tapped.
■
Open shut-off valve on CO2 distributor located
inside
of the cabinet.
IMPORTANT: Be sure to close this valve
when untapping keg.
CAUTION: Do not use keg coupler as a
handle to lift keg.
Priming the Beer System
■
Plug in top refrigeration deck, (15-amp plug),
and allow condensing unit to cycle at least
once, (circulation pump will run continuously),
before tapping the keg
.
■
Couple beer keg to system. Beer temperature
in keg should not exceed 42°F.
■
Apply 14-17 PSIG carbon dioxide gas.
■
Open faucet and pour for approximately 15
seconds.
■
Close faucet and wait for at least 15 minutes to
allow beer system to “pack”.
■
You are now ready to tap beer.
OUT
DOWN
1/4
TURN
OUT
DOWN
1/4
TURN
OUT
DOWN
1/4
TURN
Single Valve Keg Coupler
Step 1
Step 2
Step 3