Filter
Top Products
24
2 Press OK to start the installation.
If you run [Autoprogram] when you have locked channels, a
message appears asking to enter your PIN . Enter your PIN in
order to complete the installation.
If you have forgotten your PIN, reset it as described in ‘Change
your PIN’ on page 19.
3 Select [Antenna] or [Cable] and press OK.
• When [Antenna] is selected, the TV detects antenna signals. It
searches for NTSC and ATSC channels available in your area.
• When [Cable] is selected, the TV detects signals supplied by
cable. It searches for NTSC, ATSC, and QAM modulated
channels available in your area.
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
Antenna
Cable
Back
Autoprogram will rescan all channels.
Auto programming will take up to 20 minutes
to complete.
Select your signal source.
USB
Antenna
Cable
Or
ANT.IN
*The illustration is discribed for 42PFL3704D.
• When autoprogramming is complete, the lowest memorized
channel will be displayed.
4 Follow the on-screen instructions to complete the installation.
Channel List
The channels selected here can be skipped when selecting the channels
using CH +/-.
Those channels can still be selected with the Number buttons.
1 Press MENU on the remote control and select [SETUP] >
[Channel List].
PICTURE
SOUND
FEATURES
LANGUAGE
USB
SETUP
Add Channels
Antenna
Autoprogram
Channel List
7 Install Channels
The fi rst time you setup your TV, you are prompted to select a menu
language and to install TV and digital radio channels (if available). This
chapter provides instructions on how to reinstall and fi ne-tune channels.
Select Your Menu Language
1
Press MENU on the remote control and select [LANGUAGE].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
USB
Select your menu language.
Seleccione el idioma para el menú.
Sélectionnez la langue du menu.
English
Español
Français
2 Select a language and press OK to confi rm your choice.
3 Press MENU to exit.
Set Your Location to Home
You can set the location of your TV to [Home] or [Retail].
Choosing Home gives you full fl exibility to change predefi ned settings for
picture and sound.
1 Press MENU on the remote control and select [FEATURES] >
[Location].
2 Select [Home] and press OK to confi rm your choice.
3 Press MENU to exit.
Automatically Install Channels
Before you install channels, ensure that you are registered with your
cable TV provider and that your equipment is correctly connected.
1 Press MENU on the remote control and select [SETUP] >
[Autoprogram].
PICTURE
SOUND
SETUP
FEATURES
LANGUAGE
Channel List
Add Channels
Antenna
Autoprogram
USB
EN