Filter
Top Products
63
ENGLISH
63
10
Empty the (internal) drip tray and place it back. Then, press the “OK”
button.
11
Empty the milk carafe and ll it with fresh water. Insert it back in the
machine. Press the “OK” button.
12
Empty the container and place it back under the hot water/steam
wand and milk dispensing spout of the carafe. Press the “OK” button.
13
The rinsing cycle is activated. The bar shows the cycle progress.
14
When the amount of water needed for the rinse cycle has been
completely dispensed, the machine automatically ends the descaling
process by showing this display after a short heating up phase.
15
Remove and empty the container.
16
Disassemble and wash the milk carafe as described in the “Weekly
cleaning of the milk carafe” chapter.
17
Empty the (internal) drip tray and place it back.
18
Place back the “INTENZA+” water lter into the water tank if it was
installed.
EMPTY TRAY UNDER
BREW GROUP
OK
FILL HALF CARAFE
WITH WATER. INSERT
IN BREW. POSITION
OK
PLACE A CONTAINER
UNDER HOT WATER &
CARAFE DISP SPOUT
OK
PAUSE
STEP 2/2 RINSING