Filter
Top Products
70
ENGLISH
ENERGY SAVING
Stand-by
The Saeco full automatic espresso machine is designed for energy saving-
proven by the Class A energy label.
After a certain time of inactivity that can be programmed individually (see
chapter “Machine Programming”), the machine turns o automatically. If a
product has been brewed, the machine performs a rinsing cycle.
In stand-by mode, the energy consumption is below 1Wh.
To turn on the machine, press “
” button (if power button on the back of
the machine is set to “I”). If the boiler is cold the machine performs a rinsing
cycle.
The machine status can be manually changed to stand-by mode by hol-
ding the STAND-BY button for 3 seconds.
Note:
1
The stand-by mode cannot be activated if the service door is left open.
2
When the stand-by mode is activated, the machine may perform a
rinse cycle. The cycle can be interrupted by pressing the “STOP” button.
The machine can be turned on again by
1
pressing any of the control panel buttons.
2
opening the service door (when closing the door the machine goes
back to standby mode).
The red light on the “
” button ashes when the machine is in stand-by
mode.
Screen saver
The machine comes with a screen saver to extend the life of the display.
After 5 minutes of inactivity, the machine logo will start oating.
In this condition, the machine is active and pressing any button will imme-
diately activate all functions.
Note:
The screen saver is not activated if a warning signal is active.