Filter
Top Products
Note:Always test the milk on the back of your hand rst to ensure it has a safe temperature for your
baby.
Heating jars of baby food
1 Pour 20ml water into the water reservoir with the measuring cup. (Fig. 3)
2 Place the jar (max. content 150g) on the protective grid in the base. Place the cover on the
base. (Fig. 6)
3 Press (1) and turn (2) the control knob to n. (Fig. 5)
The indicator LED starts to burn red continuously and you hear a beep to indicate that the
heating process has started.
The heating process takes about 5 minutes, depending on the quantity, type and temperature
of the food.
When the food has reached the right temperature, you hear three beeps. The indicator LED
blinks red three times and then turns green.
4 Remove the cover from the base, remove the jar and unplug the appliance.
Tip:To distribute the heat better, stir the contents of the jar after heating it.
Note:Always check if the contents of the jar are at the correct temperature by testing some of the food
on the back of your hand.
You can also use the 3-in-1 Nutrition Centre to keep bottles and jars warm for a short time. After
the heating process is nished, simply leave the bottle or jar on the protective grid in the base and
leave the cover on the base. The cover retains the heat and keeps the bottle or jar warm for some
time. For microbiological and hygienic reasons, you must never keep baby food warm for more than
one hour.
Sterilising
With the container, you can use the 3-in-1 Nutrition Centre to sterilise bottles and small objects like
rubber teats and small toys. The Nutrition Centre disinfects the objects completely by destroying all
harmful bacteria.
Note:This appliance does not sterilise according to clinical standards.
Note:Before you sterilise bottles and objects, clean them rst.
1 Pour 50ml water into the water reservoir with the measuring cup. (Fig. 3)
2 Place the container on the base.
3 Place the bottles upside down in the container. (Fig. 7)
The container can contain four wide-neck bottles or six regular-sized bottles.
4 Snap the bottle necks onto the projections at the bottom of the container.
5 Place small objects in the basket and place the basket in the container. Place the lid on the
container. (Fig. 8)
6 Press and turn the control knob to /. (Fig. 5)
The indicator LED starts to burn red continuously and you hear a beep to indicate that the
sterilising process has started.
After about 15 minutes, you hear three beeps. The indicator LED blinks red three times and
then turns green to indicate that the stelising process has nished.
7 Remove the bottles and objects from the container and unplug the appliance.
,
,
,
,
,
ENGLISH8