Filter
Top Products
19
Oven not coming on when turned on manually
Is the power on? Is the clock illuminated? If
not there may be something wrong with the
power supply. Is the cooker supply on at the
isolator switch? Is the clock fl ashing 0.00?
If so set it to the correct time of day. Has
the Timer been set to AUTO by mistake. If
AUTO is showing on the clock display, press
the ‘cook period’ button and reduce any set
cooking time showing to 0.00, with the (+) and
(-) buttons. Press the
button twice.
Is the key symbol (
) showing in the display?
See the Clock section of the instructions for
more information on the key lock feature of the
clock.
Oven not coming on when automatic cooking
Timer set correctly but oven knob left OFF by
mistake?
Is the key symbol (
) showing in the display?
See the Clock section of the instructions for
more information on the key lock feature of the
clock.
Oven temperature getting hotter as the cooker
gets older
If turning the knob down has not worked or
only worked for a short time then you may
need a new thermostat. This should be fi tted
by a service person.
The oven light is not working
The bulb has probably blown. You can buy a
replacement bulb (which is not covered under
the guarantee) from a good electrical shop.
Ask for an Edison screw fi tting 15w 230v lamp,
FOR OVENS. It must be a special bulb, heat
resistant to 300 °C.
Open the oven door and remove the
Handyrack (if fi tted) and oven shelves.
Turn off the power supply.
Unscrew the bulb cover by turning
anticlockwise. Unscrew the old bulb. Screw in
the new bulb, screw back the bulb cover. Turn
on the electricity supply and check that the
bulb now lights.
Current Operated Earth Leakage Breakers
Where the cooker installation is protected by a
30 milliamp sensitivity residual current device
(RCD), the combined use of your cooker and
other domestic appliances may occasionally
cause nuisance tripping. In these instances
the cooker circuit may need to be protected
by fi tting 100mA device. This work should be
carried out by a qualifi ed electrician.
Power failure
In the event of a failure in the electrical supply
the hotplate may be lit using a match.
If there is an installation problem and I don’t get
my original installer to come back to fi x it who
pays?
You do. Service organisations will charge
for their call outs if they are correcting work
carried out by your original installer. It’s in your
interest to track down your original installer.
What cleaning materials are recommended for the
cooker?
See the ‘Cleaning your cooker’ section for
recommended cleaning materials. We do
not recommend Mr. Muscle, as it contains
chemicals that may damage the surfaces of
your cooker.