Filter
Top Products
13
Removing the Oven Shelf Supports
The oven shelf supports can be easily removed for cleaning.
First remove the all of the oven shelves and the grill pan.
Squeeze the two lower wires of the oven shelf frame together
to clear the retaining peg (Fig.5-3). Turn the frame into the
oven cavity and drop clear of the supporting holes.
Removing the Oven Linings
Some of the lining panels can be removed for cleaning.
You will need to remove the shelves and supports before
removing the panels.
Each lining panel is held in place by the oven shelf support
and a fixing tab at the top of each panel (Fig.5-4). Simply lift
each side panel upwards and then pull them forwards.
Once the linings are removed, the oven enamel interior can
be cleaned.
Glide-out Grill
The grill pan and grid should be washed in hot soapy water.
After grilling meats or any foods that soil, leave to soak for a
few minutes immediately after use. Stubborn particles may
be removed from the grid using a nylon brush. Alternatively,
the grill pan can be washed in a dishwasher.
Before you remove any of the grill parts for cleaning,
ensure that they are cool, or use oven gloves.
The grill pan can be easily removed for cleaning by lifting it
off the smooth-glide arms.
For safety's sake, push the arms back into the grill chamber.
Each smooth-glide arm is held in place on the support by
2 spring-loaded retaining brackets.
To remove the arm, first remove the oven shelf support from
the oven. This will give access to the 2 retaining clips on
the back face of the smooth-glide arm. Carefully pull open
the spring clips and lever the brackets away from the wire
support (Fig.5-5).
DO NOT use any abrasive substances. DO NOT put the
side runners in a dishwasher.
To refit a smooth-glide arm, locate the 2 retaining brackets
onto the support then push both brackets back onto the wire
frame until the spring clips ‘snap’ the arm into place.
Refit the wire supports to the oven. Replace the grill pan onto
the smooth-glide arms.
ArtNo.325-0021 BI oven removing the liners
Fig.5-4
Fig.5-3
ArtNo.325-0007 - Fitting the smooth-glide arm
Fig.5-5