Rangemaster U109200-03 Refrigerator User Manual


 
U109200-03 16
Changing the light bulb
Before replacing the light bulb, switch off the electricity
supply to the appliance and unplug the appliance.
Lamp required: 220 – 240V~25W (fridge only)
Lamp required: 220 – 240V~40W (freezer only)
Lamp holder: E27 (Do not exceed the
wattage given for lamps)
To replace the lamp;
1. Pull the lampshade towards you.
2.
Hold up (1) and pull out (2) the lampshade.
3. Rotate the lamp anticlockwise until the lamp is
released.
4.
Always replace the bulb with one that is identical.
Bulbs are not covered by any warranty, but can be
purchased at your local hardware store. Remember to take
the old bulb with you if you are unsure of what kind of bulb
to buy.
MAX 25W
Troubleshooting
The appliance fails to work when first connected
to the electricity supply.
Check there are no faults with the socket you are using
by plugging in an appliance you know to be working.
Make sure that you have switched the appliance ‘on’.
The voltage may be incorrect.
The appliance seems to be continually running.
The appliance will make a sound when first started; this
will gradually fade over a period of time.
The door has been opened frequently.
The door isn’t properly closed because the seals need
cleaning, or are damaged.
The door is damaged – leading to it dropping out of
correct alignment with the appliance.
The appliance has recently been filled with more food
than usual.
Ventilation is compromised – the vent requires cleaning
or clearing from obstruction.
There is inadequate ventilation around the appliance
– other appliances or units are too close. The appliance
has been overloaded with food for chilling or freezing.
The ‘Quick Freeze’ function has been switched on.
The outer casing of the appliance is warm
The appliance may become warm on the outside when
first switched on to prevent condensation forming.
The lamp does not work
The appliance is not plugged into the wall socket / a
fuse has blown.
The bulb requires replacing.
The temperature inside the appliance is not right
The door has not been closed properly.
The appliance is too close to a heat source, or in direct
sunlight.
The vents at the rear are blocked / obstructed.
The appliance is making noises
The appliance is cooled by the compressor, which will
make a certain amount of noise when the appliance is
switched on. The amount of noise depends on the age
of the appliance (older appliances may become noisier),
the positioning of the appliance (a levelled appliance is
less noisy) and how the appliance is used.
During use, you may hear the sound of the refrigerant
being circulated, and the sound of it flowing when
the compressor is off. The sound of the compressor
itself, which is a humming sound and a click when the
compressor switches off and on.
When you are starting the appliance for the first time,
or have had the appliance switched off for a prolonged
length of time, the sounds described above may be
louder.
You may hear hissing or gurgling noises from the
appliance – these are due to the automatic defrosting
process.
Piping and the evaporator may also make noises should
the ambient temperature around the appliance change.
If noises seem to be too loud, or a little unusual it
is more than likely because the appliance requires
levelling, or it is touching a unit.