Filter
Top Products
13
Min 200 cm²
Min 200 cm²
560
596
1780
38 min
550
min 200 cm²
If required, use
ller shelves to ll excess
cabinet space
All dimensions in mm
Make sure the ller shelves
do not block the ow of air
IMPORTANT: After you have completed reversing the door,
check that the door opens and shuts correctly without
fouling.
You should also check the appliance door seals. The seal
should not be creased or crushed; otherwise there will be a
gap between it and the inside of the door.
The seal must bond properly all the way around the door. If
the seal is not bonding to the appliance properly, then you
should either:
A. Use a warm damp cloth and adjust the seal until it
bonds to the appliance properly, all the way around the
door, or
B. Use a hair dryer on its lowest heat setting and lightly
heat the areas of the door seal that are not bonding
correctly. The heat will make the seal more pliable and
this will allow you to adjust the seal into the correct
position.
IMPORTANT: DO NOT heat the door seal on anything but
the lowest heat setting or heat the seal for a long period
of time, otherwise you may damage the door seal, which
would NOT be repaired under the guarantee free of charge.
The appliance must be stood on a level oor. You can use the
levelling feet to take into account any minor unevenness in
the oor.
Fitting into a Cabinet Unit
Cabinet dimensions and ventilation
requirements
The cabinet dimensions for the appliance are shown in
(Fig.4-11).
IMPORTANT: The clearance height must be exactly
1780 mm. If necessary, use extra ller shelves to ll any
excess space in your cabinet. Make sure the shelves DO
NOT block the ow of air (Fig.4-12).
The cabinet space MUST have a minimum of 200 cm² free
airow for ventilation (Fig.4-12).
The appliance will not function properly without
ventilation.
Fig.4-12
Fig.4-11