Filter
Top Products
To Change Door
And Access
Panel Color
Hondle metal edges of panels
carefully. Cut metal edges may
cause personal InJury or domage
fo other materials.
Remove two screws securing one of the
srde trim pieces. Slide tram downward
until upper edge is free of console or
end cap. Lift off trim piece.
2
n
Slide out color panel(s) and
corrugated spacer. Select panel color
you wish to hove showing and place
on top of panels.
Slide color ponel[sJ and spacer Into
the lower door trim and the groove on
underside of conSOle Gently push on
panel surface to fit panel under srde
trrm edge.
Slide the side tram prece agarnst the
console or end cop Align side tram and
mounting holes in door frame Secure
trim to door wrth screws
Loosen the upper access panel
screws and pull access panel outword.
Remove and save three screws
securing the top trim. Remove top trim.
6.
Pull out desired color panel and place
rn front of other panels and corrugated
spacer wrth desired color facing out.
7
n
Replace top trim wrth three screws
Move access panel back into position
and tighten upper access panel
screws.
Installing
Customized
Wood Door Panels
Dishwasher door panel and access
panel can be customized to match
wood cabinets.
l^t /----
-----------I
i
t
Door pan-31 ; 1%”
k :____-_- _--- -___I
‘il Lt
1
~-clL-
I
Cut panels using
n specified dimensions
[ 23%” x 19%6” x I%“) Make sure wood
grain matches directron of cabinet
wood groin
2
Rout all four sides
n of both panels t”x %”
deep to provrde room for installation
clearance.
Dlshwasher Is subject lo some
humldlly. Cover bofh sides and edges
of wood
paneIS
wlfh
mOlSlUm mSfSfOnf
Seder.
3
Remove side trim
n piece OS described
in Step 1, “To change access and door
panel color.”
hsonal ln]ury Hazard
4
Remove corrugated
n spacer and all
color
panels and save for future use
5
Install custom punel and one
n color panel (color panel must
be used] as described in Steps 3 and 4.
“To change csccess and front panel
color.”
6
Repeat Steps 1 and
n 2 of this section for
cutting custom panels for the access
panel Use specified dimensions shown.
7
Remove top trim
n piece from access
panel as described in Step 5. “To
change door and access panei
CObr.”
8
Remove corrugated
W spacer and all
color panels and save for future use.
9
Install custom panel and one
n color panel [color panel must
be used] css described in Steps 6 and Z
“To change door and access panel
color.”
PANEL E