Russell Hobbs RHDW1 Dishwasher User Manual


 
Electrical connection
The earthe
d plug of your machine should be connected to an earthed outlet supplied by suitable
voltage and current. If there is no earthing installation, have a competent electrician carry out an
earthing installation. In case of usage without earthing installed, our company will not be responsible
for any loss of usage that might occur.
At low voltage, Wash efficiency of your machine decreases.
Always use the coated plug supplied with your machine.
The machine’s electrical cable should be replaced by an authorised service or an authorised
electrician only. Failure to do so may lead to accidents.
For safety purposes, always make sure to disconnect the plug when a wash programme is finished.
In order not to cause an electric shock, do not unplug when your hands are wet.
When disconnecting your machine from the mains supply, always pull from the plug. Never pull the
cord itself.
Fitting the machine undercounter
If you wish to fit your machine undercounter, check whether you have sufficient space under your
countertop and whether the wiring-plumbing is suitable to do so.1 If you decide that the space under
the countertop is suitable for fitting your machine, remove the worktop as shown in the illustration. 2
Warning:The stand part which will settle the machine under it by removing its worktop has
to be stable in such a way not to allow balance disorder.
9
To remove the worktop, remove the screws that hold the worktop which are located at the rear of the
machine; then push the front panel 1 cm from the front side towards the rear and lift it.