Filter
Top Products
If one of program monitor lights is on and the start/Pause light flashes on and off,
Your machine’s door is open, shut the door.
If the programme won’t start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by pressing the Power On / Off button.
• Be sure that the water inlet filter and the machine filters are not clogged.
If the “Wash/Dry” and “End” lights keep flashing
• Water overflow alarm is active
• Turn off your tap and contact an authorised service.
If the control light won’t go out after a wash operation
The Power On/Off button is released yet.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
ERROR CODE
Wash /Dry End Start/Pause
ERROR
DESCRIPTION
CONTROL
Inadequate water
supply
• Make sure the water input tap is totally open and that
there is no water cut.
• Close the water input tap, separate the water input
hose from the tap and clean the filter at the connection
end of the hose.
• Restart your machine, contact the service if the error
resumes.
Error of continuous
water input
• Close the tap.
• Contact the service.
The waste water in the
machine cannot be
discharged.
• Water discharge hose is clogged.
• The filters of your machine might be clogged.
• Power off-on your machine and activate the program
cancellation command.
• If the error continues, contact the service.
Intended water
temperature could not
be reached faulty
heater and heater
sensor
Contact the service.
Alarm is active against
water overflow
• Power off your machine and close the tap.
• Contact the service.
Faulty electronic card
Contact the service.
FAILURE CODES AND
WHAT TO DO IN CASE OF
FAILURE
25