Ensure that the water inlet hose does not become compressed while positioning the
machine. Also, make sure that the machine does not stand on the electrical cable.
Ensure the machine is level when placed on the surface. Adjust the feet by twisting
clockwise to raise the height of the machine, and anti-clockwise to reduce the height
of the machine. Failure to ensure the machine is level may result in the door not
closing properly.
Water Connection
Ensure the machine is connected to a clean, cold running water supply.
Water inlet hose
Only use the water inlet hose supplied with this machine. Do not re-
use old inlet hoses. Connect the water inlet hose directly to the water
inlet tap. The pressure supplied by the tap should be a minimum of
0.03Mpa and a maximum of 1Mpa. If the water pressure is above
1Mpa, a pressure release valve should be fitted. After the connection
is made, the tap should be turned on fully and checked for water
tightness. For the safety of your machine, make sure you always turn
off the water after each cycle.
Note: Aquastop water spouts are used in some models. In case of
using aqua stop, a dangerous tension exists. Do not cut an
Aquastop water spout. Do not allow an aqua stop spout to become
twisted.
Water outlet hose
The water drain hose can be connected either directly to the water
drain hole or to the sink outlet spigot. Using a special bent pipe, the
water can be drained directly into the sink via hooking the pipe over
the edge of the sink. This connection should be a minimum of 50cm
and at a maximum of 110 cm from the floor plane. If a drain hose longer than 4m is
used dishes may remain dirty and warranty will
be void.
For Customer Services, Spare Parts & Manufacturer's Warranty Information please call 01204 664 084
-9-