Filter
Top Products
• 8 •• 8 •
Red
Orange
Orange
Green
• Switch the power button to “I” to turn
on the machine.
Priming the Water Circuit
• To prime the water circuit, place a
container under the steam/hot water
wand (Pannarello, if supplied).
• The display shows the ON/OFF icon.
• Make sure the selector dial is set to the
“ ” position; if this is not the case, set
it to that position.
• Press the ON/OFF button to turn the
machine on.
• The display indicates that the circuit
must be primed.
Note: Before starting the
machine after long periods
of inactivity, the water circuit must
be primed.
Black
Red
• Turn the selector dial clockwise to set
it to the “
” position. The machine
starts the automatic priming of the
circuit by letting out a preset quantity
of water through the steam/hot water
wand (Pannarello, if supplied). The bar
under the icon shows the operation
progress.
At the end of the priming process,
the display shows an icon (see fig-
ure) indicating that the selection dial
must be brought back to the central
“
” position.
• The display then shows the machine
warm-up icon, as shown in the gure.
When warm-up is complete,
the machine performs a rinse
cycle of the internal circuits.
In this phase, this icon will be dis-
played:
• When the operations described above
are complete, this icon will be dis-
played:
The machine is then ready to brew
beverages.
• To brew co ee, dispense hot water or
steam, and for a proper use of the ma-
chine, carefully follow the instructions
provided.
If the machine is being used
for the rst time or after a
long period of inactivity, follow the
operations described in the follow-
ing section.