Filter
Top Products
ENGLISH
15
The control panel display guides users and helps them to use the machine correctly.
Fit the brew unit properly in place.
Brew unit jammed: contact an authorised
service centre.
Descale the machine
Remove the dregs drawer and empty out the
dregs into a suitable container.
Important note: the dregs drawer may
be emptied only when the machine is on. The drawer must be removed for at
least 5 seconds. If you empty the drawer with the machine off, you will not be
able to dispense coffee the next time you switch the machine on.
Fit the drip tray and dregs drawer properly
in place.
Fill the coffee bean container with coffee
beans and start the coffee brewing cycle.
Coffee grinder jammed: contact an autho-
rised service centre.
Fill the water tank with fresh drinking
water.
Place a container beneath the steam tube
and load the circuit as directed on page 6.
Machine temperature low.
Boiler temperature too high, load the circuit
as directed on page 10.
Power on.
Machine in Stand By mode.
DISPLAY MESSAGES
Flashing
Steadily lit
Steadily lit
Flashing
Steadily lit
Flashing
Steadily lit
Flashing
Steadily lit
PROBLEMS CAUSES REMEDIES
The machine does not
turn on.
The machine is not
connected to the power
supply.
Move the main switch to ON.
Check the plug and the
connection
The coffee is not hot
enough.
The cups are cold. Warm up the cups.
Only water is dispen-
sed when you select
“preground coffee”.
No preground coffee has
been introduced.
Dispense again after
introducing preground coffee.
No hot water or steam
is dispensed.
The tube nozzle is
clogged.
Clean the nozzle opening
with a needle.
During this ope-
ration, the knob must
be closed and the machine
must be off.
The machine takes a
long time to warm up.
Excessive scale has
built up.
Descale the machine.
The brew unit cannot
be removed.
The unit has stopped in
the wrong position.
Close the door and switch on
the machine; the brew unit
will move back into position.
Off
Flashing
Steadily lit
Flashing