Filter
Top Products
14
GB
Error Codes
Error Items Code Error Beep Cause/Remedy
Cause: Power frequency is other than 50 Hz.
Remedy
: • Unplug the power cord plug and check if the
power frequency is 50 Hz.
• Plug the power cord in 50 Hz power source and
see If “E1” appears. If the error code is displayed
again even after the correct power source is
provided, contact the nearest service centre.
Power frequency Error(50/60Hz) E1
one beep
for 2 sec
Care of Your Microwave Oven
Cleaning the Microwave Oven
1 Unplug the oven from the electrical socket before cleaning.
2 Clean the inside of the oven. Wipe up all spills with a damp cloth. Kitchen
detergent solution may be used if the oven gets too dirty. Do not use harsh
detergents or abrasives.
➢ If food remnant or spilled liquids stick to the oven walls, or between
door seal and door surface, they will absorb microwaves possibly
resulting in arcing or sparks.
3 Clean the outside of the oven with soap and water, then dry with a soft cloth.
Caution: Make sure that water does not get into the back ventilation or
control panel opening.
4 When you clean the window of the door, be sure to use a soft cloth after
washing with very mild soap and water. Do not use window cleaner as the
front door can be scratched by harsh soap or cleaners.
Cleaning the Ceiling Cover
1 Hold side stoppers of ceiling cover with both hands and pull them in and
down. Then take the ceiling cover out of the oven cavity.
2 Rinse ceiling cover in soapy water or Food Sanitizer Solution.
3 Be sure to replace the ceiling cover before using the oven.
CAUTION
Ceiling cover must be in place securely when you use the oven.
When you removed the Ceiling Cover for the purpose of cleaning, be
sure to be extremely careful about the exposed inside components on
the top of the oven cavity. If any of them are deformed, abnormal
symptom can happen such as arcing or sparks during operation. In case
of such problem, contact the nearest after-sales service centre.
Ceiling Cover
CM1019-EU 2/11/00 4:57 AM Page 14