Filter
Top Products
12
Operation
Reading each Memory Program’s Cycle
Counter
1 Press the Check button.
The display will be cleared.
2 Press the Start button, then any Number button, from 1 to 20. The
number of cycles for that particular Memory Program will be
displayed. The cycle count is displayed in units of 10. For example,
if Memory Program 5 has been used 100 times, the display will
show “10”.
As the display uses units of 10, the cycle counts are approximate. The
cycle count displayed increases every ten cycles. For example, if the
cycle count were 90-99, “9” would be displayed, The “9” would change to
“10” on the 100th cycle. The cycle counter function has a limit of 99,990
cycles. Once that number is exceeded, the cycle counter will
automatically clear and start again from “0”.
3 After one second, the display will clear automatically. If you want to
check the cycle count of other Memory Programs, just enter the
Memory Program numbers.
4 Press the Stop/Clear button to exit the Checking mode.
Resetting the Memory Program Cycle Counter
1 Clear all operations by pressing the Stop/Clear button.
The display will show “ : 0 “ or the present time (If the time is set).
2 Press Number “ 0 “ and the Auto Defrost button at the same time.
The Microwave will emit a Beep sound confirming the reset
operation. The display will show “ : 0 “ or the present time (If the time
is set).
Setting the Sound
1 Press the Sound button to adjust sound volume. The basic sound
volume is "LO". Press the Sound button repeatedly, to change the
volume in the following order - MED, HI, OFF, LO.
2 Press the Start button to exit the Sound mode.
The display will show “ : 0 ” or the present time (If the time is set).
Indicator Sound
HI Loud
MED Middle
LO Low
Blank Off
jt`Y`iniUGGwGXYGG{SGuGYWSGYWWXGGXWaZZGht