Filter
Top Products
7
EN
Setting the Time
Your microwave oven has an inbuilt clock. The time can be displayed
the only 24-hour notation. You must set the clock:
• When you first install your microwave oven
• After a power failure
✉ Do not forget to reset the clock when you switch to and from summer
or winter time.
Checking that Your Oven is Operating Correctly
The following simple procedure enables you to check that your oven is
working correctly at all times. If you are in doubt, refer to the section
entitled “What to Do if You are in Doubt or Have a Problem” next the
page.
✉ The oven must be plugged into an appropriate wall socket. The
turntable must be in position in the oven. If a power level other than
the maximum (100% - 900 W) is used, the water takes longer to boil.
Open the oven door by pulling the handle on the right side of the door.
Place a glass of water on the turntable. Close the door.
1. Turn the Jog Dial to set the hour.
Next : Press the blinking button.
2.
Press the
start
( ) button.
Next : Turn the blinking dial.
3.
Turn the
Jog Dial
to set the minute.
Next : Press the blinking button.
4.
When the right time is displayed, press the
start
( ) button.
Result: The time is displayed whenever you are not
using the microwave oven.
Press the
start
( ) button and set the time to 4 or 5 minutes,
by pressing the
start
( ) button the appropriate number of
times.
Result: The oven heats the water for 4 or 5 minutes.
The water should then be boiling.
jlXX_WniivsTWZW][yluUGGwG^GGmSGqGXWSGYWW\GGXXaYXGht