Filter
Top Products
58_ maintaining your appliance
Surface burner grates and assemblies
1. Turn o all controls and make sure all parts have cooled.
2. Lift o and remove the burner
grates from the cooktop. Make
note of the burner sizes and
locations of all the surface burners.
3. Lift o burner caps from top of the
burner heads.
4. Lift the burner heads o the valve
manifolds and starter electrodes.
5. Clean all removable burner parts in warm, soapy water. Do not use steel-wool
pads or abrasive cleaners on any burner part.
6. Rinse thoroughly and completely dry all parts before they are reassembled.
Starter electrodes are not removable and should only be wiped clean when
the controls are in the OFF position.
7. Set all burner heads on top of
the manifold valves in the same
location you removed them from.
The hole on the side of the burner
heads goes over the electrodes.
The burner heads are correctly
installed when they are flat on the
top of the manifold valves.
8. Set all burner caps on top of the
burner heads.
These also need to be flat on top of the burner heads to ensure proper and
safe operation.
(IB)FX710BGS,FX510BGS,NX583G0VB_DG68-00356A-06_EN.indd 58 2013-05-07 �� 6:24:28