Filter
Top Products
When the left
door is lower
than the right
door.
When the left
door is higher
than the right
door.
Adjustment
part
Adjustment
part
1. Pull out the freezer drawer ( 1 ), then you can see the middle hinge ( 2 ) .
2. Insert the supplied hex wrench ( 3 ) into the shaft ( 4 ) of the middle hinge.
3. Please adjust the height by turning the hex wrench ( 3 ) clockwise (
) or counter-clockwise ( ).
1. After adjusting the doors, please insert the supplied fastener ( 5 ) using Pliers ( 6 ) in the gap between
the hinge-grommet ( 7 ) and the middle hinge ( 8 ). The number of fasteners you’ll need to insert
depends on the gap.
2
3
4
1
3
MAKING MINOR ADJUSTMENTS BETWEEN DOORS
Remember, a level Refrigerator is necessary for getting the doors perfectly even. If you need help, review the
previous section on leveling the Refrigerator.
Setting up your French Door Refrigerator
When you turn the hex wrench counter-clockwise( ), the door will move up.
2 fastener are enclosed with the refrigerator.
The thickness of each fastener is 0.04”.
INSTALLATION OF THE WATER LINE
Before You Install the water line
• The water line installation is not warranted by the refrigerator manufacturer.
So before you install the water line, read the whole steps for installing and follow these instructions
carefully to minimize the risk of expensive water damage.
• Banging pipes (water banging in the pipes) in house plumbing can cause damage to fridge parts and
lead to water leakage or flooding. Call a qualified plumber to correct the problem before installing the
water supply line to the fridge.
• To prevent burns and product damage, do not hook up the water line to the hot water line.
• Do not install the water line in areas where temperatures fall below freezing.
• When using any electrical device (such as a power drill) during installation, be sure the device is
insulated or wired in a manner to prevent electric shock.
• All installations must be in a accordance with local plumbing code requirements.
Connecting to water supply line
• Shut off the main water supply line and turn the Ice maker
to the off position.
• Locate the nearest cold drinking water line.
• Follow the instructions in the water lter installation kit.
• After connecting the water supply line to the Cartridge
Holder inlet (insert plastic line in fully), install the Filter
Cartridge.
• Turn on water supply and Flush 3 gallons through lter
before use (flush approximately 6 minutes)
• Water line Kit and water lter are not covered by Samsung’s Warranty. The manufacturer (or dealer,
installer) of them is responsible for any defects and all the loss caused by water filter & water line
kit .
• The lter should be replaced according to manufacturer (or dealer)’s instruction.
• To order additional water lters, please contact the manufacturer (or dealer) of the lter.
• If you want to install a water lter, it must be installed outside
the refrigerator.
It is not provided with your new refrigerator. The filter cartridge
(8) and holder (9) kit can be purchased from the retailer where
you purchased this refrigerator.
• Do not use copper line.
• Cut the tubing, making sure the ends are square and clean.
90 degree
1. Cold Water line
4. Compression Nut
8. Filter Cartridge
9. Cartridge Holder
Incorrect Correct
16_
setting up
setting up
_17
01