Filter
Top Products
18_ setting up
4. Lock the Cylinder into place by pressing the Lever.
• The inner pressure of the Cylinder may make it difficult to press the lever down. Hold
the lever as shown in the illustration on the right, and then push down.
• If you don’t lock the cylinder into place, the refrigerator won’t produce sparkling
water.
• If the cylinder is not tightly connected to the Regulator, it will leak CO
2
gas, producing
a hiss. If this occurs, repeat Steps 2, 3, and 4, making sure that the cylinder is firmly
attached and locked into place.
5. Press the Sparkling Water button 3 seconds to run the Cylinder Reset function. Wait about 20 minutes. (the
amount of time needed for a medium level of carbonation) while the refrigerator makes sparkling water.
• To make sparkling water, the refrigerator injects CO
2
from the CO
2
cylinder into water stored in the Sparkling
Water tank. The water enters the tank through the refrigerator’s water supply line.
Press 3 seconds
Press 3 seconds
6. To remove any residual substances that may be in the water, dispense 2 or 3 large glass fulls of Sparkling Water
and empty them into a sink.
For more information about using the Sparkling Water function, see Using the Sparkling Water Function.
Completing the Set Up
Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the
features and functions of the appliance. By completing the following steps, your refrigerator should be
fully operational.
1. Make sure your refrigerator is in an appropriate location with reasonable clearance between it and
the wall. Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get
slightly chilled and the motor will run smoothly. Reset the refrigerator and freezer to the temperatures
you want.
4. After you plug the refrigerator in, it will take a few hours to reach the appropriate temperature. You
can store food and drinks in the refrigerator after the temperature is sufficiently cool.
If condensation or water drops appears on both sides of fridge door’s central part, turn the
Energy Saver mode off after removing the condensation. (See the explanation on Energy Saver
button in the USING THE CONTROL PANEL.)
DA68-02894A-09.indb 18DA68-02894A-09.indb 18 2013. 12. 3. 8:452013. 12. 3. 8:45