Filter
Top Products
34_ operating
The Carbonation Level is set to Level 2 at the factory. If the sparkling water tastes too strong or
too weak, change the carbonation level. Level 1 provides a milder carbonation, Level 3 a stronger
carbonation.
• If there is a power interruption when the refrigerator is making sparkling water, the refrigerator may
re-start the carbonation process when power returns and put too much carbonation into the water.
If this occurs, we recommend throwing out the overly carbonated water and starting the process
again.
• The lifetime of the CO
2
cylinder can vary, depending on the Carbonation Levels you choose.
Turning Off the Sparkling Water Function
To turn off the Sparkling Water function, press the Cubed/Crushed button for 3 seconds.
Any sparkling water remaining in the Sparkling Water tank after you have turned off the Sparkling Water
function can still be dispensed.
Replacing a Cylinder
When the taste of sparkling water is weak or non-existent, replace the current cylinder with a new
cylinder. To replace a cylinder, follow these steps:
1. Lift up the Lever holding the cylinder in place.
2. Pull the Cylinder out of the Support.
3. Rotate the Cylinder counterclockwise to remove it from the Regulator.
4. To install a new cylinder, follow the directions for installing a cylinder starting at Step 2 in Installing a Cylinder into
the Refrigerator on pages 17 and 18.
OFF Icon On
OFF Icon On
Press for 3
Press for 3
seconds
seconds
DA68-02894A-09.indb 34DA68-02894A-09.indb 34 2013. 12. 3. 8:452013. 12. 3. 8:45